APW Wyott VSX - Manual (Page 7)

%
Release Sheet Care and Replacement
6. TROUBLESHOOTING GUIDE
Always ask and check the following:
1. Is the unit connected to a live power source of the proper voltage?
2. Check the circuit breaker.
3. Is power switch “ON” and pilot light glowing?
4. Check the rating label. Is the unit connected to the correct power source?
5. Is the Top Lid properly secure on top and engaging the Conveyor Button? (See Figure L above).
Service Hotline
(800) 733-2203
J/K N L M
F G
A
I
B C D/E
H
A. Turn toaster off.
B. Remove the Top Cover.
C. Remove old Release Sheet from the toaster platen. TOASTER PLATEN MAY BE HOT.
D. Using a cleaning pad or sponge, clean both sides of the sheet with a cleaner (we recommend Sizzle Plus by
Kay Chemical, www.ecolab.com). Then rinse and sanitize both sides.Always clean both sides.
E. Inspect both sides of the Release Sheet to see if they are still good (fairly clean and slick). If one side of the
Release Sheet doesn’t allow buns to slide over it in the toaster, then that side of the sheet is no longer good.
When neither side allows the buns to easily slide through the toaster, it is time to replace the sheet. It is best to
use up one side of the sheet, and then switch to the other side.
F. When switching sides or using a new Release Sheet, fold the Release Sheet in half (length-wise) and
crease it. The buns will touch the side that is facing out.
G. Turn toaster on.
H. Move the conveyors out full. (The Bun Thickness Dials should point straight up.)
I. Drape the Release Sheet over the toaster platen and go about 5” down.
J. While holding the Release Sheet with one hand, press the conveyor button on top to start the conveyors. As
the conveyors turn, they will help the Release Sheet to go down. BUTTON MAY BE HOT.
K. When the crease reaches the top of the platen, release the Conveyor Button.
L. Replace the top cover to the toaster.
M. Let the toaster run for about 10 minutes to warm up the Release Sheet.
N. Re-adjust the conveyors to their proper settings using the Bun Thickness Dials.
CAUTION!
Do not switch back-and-forth between sides since this
will wear out the sheet at the crease.
lightly
(Conveyors will not run because top cover is removed.)
CAUTION!
(Conveyor starts to move.)
TM