Telenav bluetooth gps configuration, Addresses, Address selector – Telenav for AT&T Supported Devices: v4.1 for Palm Treo 750 User Manual
Page 11: Recent addresses
TeleNav Bluetooth GPS Configuration
The GPS location information is provided by a TeleNav Bluetooth GPS receiver,
therefore you must configure the GPS receiver before you can access
information that is dependent upon GPS information in TeleNav.
Make certain that your TeleNav Bluetooth GPS receiver is powered ON at this
point during the setup. Press Yes to configure the settings. A scan of all nearby
devices will be completed and a list will be displayed. Highlight the TeleNav
GPS option and press OK to continue.
6. Addresses
This section discusses the variety of ways you can select a previously entered address, enter a new one, or use a
Business or Airport Address. This information is presented here since the techniques for setting addresses are
used throughout TeleNav.
Address Selector
TeleNav presents a list of options for you to choose from when a) setting a
destination address, b) setting an origin address, c) defining the center of a
displayed map, or d) anchoring a Business Finder search.
These options include: a) using an airport’s address, b) entering an address
from the keypad, c) verbally dictating an address to an automatic voice
recognition system, d) using the address of a business, e) using a Recent City,
Recent Stop, or a previously stored Location.
NOTE:
One or more options may be omitted from the Address Selector list
depending upon the application context.
Recent Addresses
Recent Addresses are addresses used recently for navigation, directions,
business finder searches, or mapping. When the 24-item capacity of the list is
exceeded, the newest stop pushes the eldest off the list. When a stop in the list
is used within TeleNav, it is promoted to the head of the list.
Press Menu and select “Refresh” to pull in any addresses you entered on the
website Preplanning feature.
© TELENAV 2003-6
PAGE 11 OF 29