Tuff Country 16090 - GM 2011 Silverado 3500HD 6 box kit - Manual (Page 19)

76. Locate (2) S10102 sleeves from hardware bag 16085PL.
Also, locate (2) 7/16” USS flat washers and (2) 1/2” uni-
torque nuts from hardware bag 16085NB2. Working on the
driver side, slide the new sleeve over the carriage bolt and
then install the new sway bar end link to the lower control
arm and secure using the new 1/2” hardware. Do not tight-
en at this point. Repeat procedure on the passenger side
77. Locate (4) sway bar end link bushings, (4) coned wash-
ers and (2) 3/8” fine nuts from hardware bag 16085PL.
Working on the driver side, install the newly installed end link
to the sway bar using the new poly bushings and hardware.
Do not tighten at this point. Repeat procedure on the pas-
senger side.
78. Working on the driver side, move back to the lower car-
riage bolt that is attaching the lower end link bracket to the
lower control arm and add some loctite and torque to 35 ft
lbs. Now, add some loctite to the 1/2” hardware that is
securing the end link to the lower bracket and torque to 75 ft
lbs. Finally, add some loctite to the sway bar end link where
it is attached to the sway bar and tighten until bushings starts
to bulge. Repeat procedure on the passenger side.