Tuff Country 16955 - GM 99-05 Silverado K1500 6 kit User Manual
Page 6
11. Working on the driver side, remove the stock brake line
bracket that connects to the top of the stock steering
knuckle and save the stock hardware. Next, remove the
stock bolt that connects the stock brake line bracket to the
upper control arm, and save hardware for later re-installa-
tion. Repeat procedure on the passenger side.
12. Working on the driver side, locate the ABS line quick
disconnect located above the stock upper control arm.
Disconnect the ABS lines from each other. Also, disconnect
the ABS line from any other mounting points on the stock
frame rail, stock upper control arm and the stock brake line
bracket that was removed from the stock knuckle. Repeat
procedure on the passenger side.
13. Working on the driver side, remove the (2) stock bolts
that connect the stock brake caliper to the stock knuckle.
Save the stock hardware for later re-installation. Using a
bungee cord, carefully tie the stock brake caliper up and
out of the way in the fender well. Special note: Take
special care not to kink or over extend the stock brake
line. Repeat procedure on the passenger side.
14. Working on the driver side, remove the stock rotor and
set aside for later re-installation. Repeat procedure on the
passenger side.