Tuff Country 24810 - Ford 80-96 F150 4 Lift Kit - Manual (Page 5)

6. Working on the front driver side twin eye beam axle,
remove the stock mounting hardware that connects the front
twin eye beam axle to the stock bracket. The stock hardware
may be discarded.
7. Working on the front driver side twin eye beam axle brack-
et, remove the stock bracket from the stock location. Save
the stock hardware but the the stock bracket may be dis-
carded.
8. Working on the rear passenger side twin eye beam axle,
remove the stock mounting hardware that connects the rear
axle to the stock location. Save the stock hardware.
9. Working on the driver side stock radius arm bracket,
remove the stock hardware or the stock rivets that connect
the bracket to the frame rail. The stock hardware and rivets
may be discard. Repeat procedure on the passenger side.
Special note: Using a die grinder and making a cross cut
on the rivets then using a air chisel will help make the
removal of the rivets easier.
10. Make sure that the hydraulic floor jacks are supporting
the front and rear twin eye beam axles and the stock radius
arms.
11. Locate the new front twin eye beam relocation bracket
and the stock hardware. Install the new front relocation
bracket to the stock location and secure using the stock
hardware. Make sure to use thread locker or loctite and
torque to 85 ft lbs.