Tuff Country 24810 - Ford 80-96 F150 4 Lift Kit - Manual (Page 7)

17. Locate (2) 1/2” x 1 1/2” bolts, (4) 7/16” USS flat washers
and (2) 1/2” unitorque nuts from hardware bag F4NB.
Secure the new rear twin eye beam axle pivot relocation
bracket to the cross member using the new 1/2” x 1 1/2”
bolts and hardware. Make sure to use thread locker or loc-
tite and torque to 75 ft lbs.
18. Locate (1) 9/16” x 3 1/2” cam bolt, (2) cam washers and
(1) 9/16” unitorque nut from hardware bag CAM1NB.
Carefully raise up on the hydraulic floor jack that is support-
ing the passenger side rear twin eye beam axle until it slides
up into the newly installed bracket. Secure the axle to the
new bracket using the new cam bolt and hardware. Make
sure to use thread locker or loctite and torque to 85 ft lbs.
Special note: For now, place the cam washer in the cen-
ter position.
19. Working on the driver side, remove the stock coil clip
from the stock location and save the stock hardware and coil
clip. Now remove the stock hardware that connects the stock
coil spring to the stock front twin eye beam axle. Save the
stock nut and coil washer. Remove and discard the stock coil
spring. Repeat procedure on the passenger side. Part #
24810 does not include the front coil springs. Part #
24811 is the part # for the front coil springs and they
need to be ordered as a septate part #. If you have not
already ordered your new front coil springs, please con-
tact Tuff Country or your local Tuff Country dealer and
order the new
front coil springs.
20. Using a 1/2” drill bit, carefully clean the stock frame rail
on the driver and passenger side and also clean each hole
on the stock driver and passenger side radius arm relocation
bracket.
21. Locate the driver and passenger side radius arm reloca-
tion brackets. Locate (8) 1/2” x 1 1/2” bolts, (16) 7/16” USS
flat washers and (8) 1/2” unitorque nuts from hardware bag
F4NB. Working on the driver side, install the new radius arm
relocation bracket into the stock location and secure using
the new 1/2” x 1 1/2” bolts and hardware. Do not tighten at
this point. Repeat procedure on the passenger side.
22. Locate (8) 1/2” x 1 1/2” bolts, (16) 7/16” USS flat wash-
ers and (8) 1/2” unitorque nuts from hardware bag F4NB.
Working on the driver side, install the stock driver side radius