Tuff Country 24814 - Ford 80-96 F150 4 performance box kit - Manual (Page 13)

53. Locate (2) e-clips from hardware bag FBLNB2. Working
on the driver side, install the new e-clips to the stock brake
line on the back side of the newly installed brake line reloca-
tion bracket. Repeat procedure on the passenger side.
Special note: Once the completion of the suspension
system has performed and the weight of the vehicle is
on the ground, check to make sure that the stock brake
line does not rub on the inside of the tire.
54. If you have not already done so, remove all the hydraulic
floor jacks from under the vehicle. Check and double check
to make sure that all steps have been performed properly
and check again. Install the tires and wheels and carefully
lower the vehicle to the ground.
55. If you were not able to install the stock sway bar to the
newly installed sway bar relocation brackets, perform this
step now that the weight of the vehicle is on the ground.
Front end installation completed!
Rear end installation:
Part # 24814/F4XRB does not include anything to com-
plete the rear end of the vehicle. Part # 24813/F4RD is
the part # for the rear end and needs to be ordered as a
septate part #.
56. To begin installation, carefully block the front tires and
wheels so that the vehicle can not roll forward. Safely lift the
rear of the vehicle and support the vehicle with a pair of jack
stands. Place a jack stand on both the driver and the pas-
senger side. Next, remove the rear wheels and tires from
both sides.
57. Working on the driver side, remove the stock shock from
the stock location. The stock shock may be discarded but
save the stock upper and lower hardware. Repeat procedure
on the passenger side.
58. Working on the driver side, remove the stock sway bar
end link from the stock sway bar. Save the stock hardware.
Repeat procedure on the passenger side.
59. Place a pair of hydraulic floor jacks under the rear differ-
ential. Carefully raise up on the hydraulic floor jacks until
they make contact with the rear differential.
60. Working on the driver side, remove the stock u-bolts from
the stock location. The stock u-bolts and hardware may be
discarded. Save the stock upper u-bolt plate. Repeat proce-
dure on the passenger side.
61. Carefully lower down on both hydraulic floor jacks at the
same time allowing enough room for the new rear add-a-
leafs to be installed. Working on the driver side, remove the
stock block from the stock location and set aside. Repeat
procedure on the passenger side.