Tuff Country 24975 - Ford 08-14 F250/F350 5 box kit - Manual (Page 6)

13. Locate the new pitman arm, and the new 30mm pitman
arm nut. Install the new pitman arm onto the steering box
sector shaft. Make sure to install it in the same orientation
that the original was removed. Install the new nut and
torque to 350 ft lbs.
14. Locate the new track bar relocation bracket and the OE
track bar bracket hardware. Install the new bracket into the
original location on the frame rail. Special note: the part
of the bracket with the 3 holes will be installed on the
back side of the engine crossemember, this is oppo-
site of how the OE bracket was mounted. Torque nuts
to 75 ft lbs.
15. Working on the driver side, remove the rubber bump
stop and un-bolt the bumpstop cup from the bottom of the
frame rail, save bolts. Repeat on the passenger side.
16. Locate (2) bumpstop relocation brackets, also locate
(2) 5/16” x 1” bolts, (4) 1/4” flat washers, and (2) 5/16”
uni-torque nuts from hardware bag 24975NB. Using the
OE bolt, connect the bumpstop relocation brackets to the
bottom of the frame rail in the original location. Using new
5/16” hardware, attach the bumpstop cup to the new relo-
cation bracket. Torque bolts to 10 ft lbs and re-install rubber
bump stop into the cups.