Tuff Country 43001 - Jeep Wrangler 3 kitt - Manual (Page 3)

Hardware bag 43000NB includes:
Description Quantity
916312B (9/16”x 3 1/2” bolt) 1
12WA (1/2” USS flat washer) 2
916UN (9/16” unitorque nut) 1
381B (3/8” x 1” bolt) 4
516WA (5/16” USS flat washer) 2
38FLN (3/8” flange lock nut) 4
38LWA (3/8” lock washer) 2
12212B (1/2” x 2 1/2” bolt) 2
716WA (7/16” USS flat washer) 6
12UN (1/2” unitorque nut) 2
1434B (1/4” x 3/4” bolt) 2
14WA (1/4” USS flat washer) 4
14UN (1/4” unitorque nut) 2
Hardware bag 43000NB1 includes:
Description Quantity
43000-02 (rear brake line bracket) 2
43000-03 (rear coil spring retaining washer) 2
43000-04 (nut bracket) 1
S10026 (.680” x .500” x 1.500” sleeve) 4
MO2220 (poly bushing) 8
S10065 (1.250” x .563” x 1.600” sleeve) 1
BP21 (clevis mount) 2
Please follow instructions carefully:
Before installation begins, measure from the center of
the hub, to the bottom of the fender well, and record
measurements below.
Pre-installation measurements:
Driver side front:_________________________________
Passenger side front:_____________________________
Driver side rear:__________________________________
Passenger side rear:______________________________
At the end of the installation take the same
measurements and compare to the pre-installation
measurements.
Post-installation measurements:
Driver side front:_________________________________
Passenger side front:_____________________________
Driver side rear:_________________________________
Passenger side rear:______________________________
Front end installation:
1. To begin installation, carefully lift the vehicle into the air
and support the vehicle with jack stands. Place a jack stand
on both the driver and the passenger side. Also at this time,
place a pair of hydraulic floor jacks under the front and rear
axle. Next, remove the front wheels and tires from both
sides.
2. Working on the driver side, remove the front sway bar end
link from the axle mount and sway bar. Save the lower hard-
ware but the sway bar end link may be discard. Repeat pro-
cedure on the passenger side.
3. Working on the driver side, remove the rear sway bar end
link from the axle mount and the sway bar. Save the hard-
ware and end link. Special note: the stock rear sway bar
end link will be installed in the front of the vehicle.
Repeat procedure on the passenger side.
4. Working on the driver side, remove the hardware attach-
ing the OE brake line bracket to the side of the frame rail.
Save the hardware and repeat on the passenger side.
5. Working on the driver side, remove the shock from the
vehicle. Save the hardware. The shock maybe discarded.
Special note: New longer front shocks are needed after
this suspension system has been installed and the
shocks need to be ordered as a separate part #. If you
have not already ordered your shocks, please feel free
to contact Tuff Country or your local Tuff Country deal-
er and order your new shocks. Tuff Country recom-
mends installing a 26” fully extended shock in the front.
6. Carefully lower down on both hydraulic floor jacks at the
same time allowing enough room for the coil springs to be
removed remove.
Working on the driv-
er side, remove and
discard the coil
springs. Repeat
procedure on the
passenger side.