Tuff Country 54070 - Toyota Tundra 07-14 4 lift kit - Manual (Page 11)

40. Carefully lower down on both hydraulic floor jacks at the
same time allowing enough room for the rear blocks to be
installed. Special note: Take special care not to over
extend any brake lines and/or hoses.
41. Locate (2) new 2” lifted blocks. Working on the driver
side, install the new 2” lifted block into the stock location.
Repeat procedure on the passenger side. Carefully raise up
on both hydraulic floor jacks at the same time until the spring
assembly sits flush with the newly installed 3” lifted block.
42. Locate (4) 9/16” x 2 9/16” x 9 5/8” square u-bolts. Locate
(8) 9/16” u-bolt high nuts and (8) u-bolt washers from hard-
ware bag 916NW. Also, locate the lower u-bolt plates.
Working on the driver side, install the new u-bolts into the
stock location and secure using the new 9/16” high nuts and
washers. Special note: If need be, cut off the excess
threads off each leg of the newly installed u-bolts.
Torque to 120 ft lbs. Repeat procedure on passenger side.
43. Locate the new emergency brake cable extension brack-
ets. Working on the driver side, install the new emergency
brake cable bracket to the rear axle using the OE hardware.
Do not tighten at this point. Repeat procedure on the pas-
senger side.
44. Locate (2) 5/16” x 1” bolts, (4) 1/4” USS flat washers and
(2) 5/16” unitorque nuts from hardware bag 54070NB1.
Working on the driver side, secure the OE emergency brake
cable to the newly installed emergency brake cable bracket
using the new 5/16” hardware. Make sure to use loctite and
torque to 12 ft lbs. Repeat procedure on the passenger side.
Move back to the OE hardware attaching the new bracket to
the axle on the driver and passenger side and torque to 8 ft
lbs.