Tuff Country 54070 - Toyota Tundra 07-14 4 lift kit - Manual (Page 3)

Hardware bag 54070NB includes:
Description Quantity
S10051 (1.750” x .510” x .950” sleeve) 2
S10077 (oversize washer) 4
S10239 (.750” x .625” x 2.348” sleeve) 4
PB69137 (poly bushing) 8
Hardware bag 54070NB1 includes:
Description Quantity
126B (1/2” 6” bolt) 2
716WA (7/16” USS flat washer) 2
12UN (1/2” unitorque nut) 2
38NLN (3/8” nylon lock nut) 8
516WA (5/16” USS flat washer) 8
5161B (5/16” x 1” bolt) 2
14WA (1/4” USS flat washer) 6
516UN (5/16” unitorque nut) 2
14UN (1/4” Unitorque nut) 2
SUW-916 (9/16” u-bolt harden washer) 2
SERT04 (sert fitting) 4
M1260B1.25 (12 mm x 60 mm bolt) 4
M12WA (12 mm flat washer) 4
M12LWA (12 mm lock washer) 4
Hardware bag 916NW includes:
Description Quantity
916HN (9/16” u-bolt high nut) 8
SUW-916 (9/16” u-bolt washer) 8
Please follow instructions carefully:
Before installation begins, measure from the center of
the hub, to the bottom of the fender well, and record
measurements below.
Pre-installation measurements:
Driver side front:_________________________________
Passenger side front:_____________________________
Driver side rear:__________________________________
Passenger side rear:______________________________
At the end of the installation take the same
measurements and compare to the pre-installation
measurements.
Post-installation measurements:
Driver side front:_________________________________
Passenger side front:_____________________________
Driver side rear:_________________________________
Passenger side rear:______________________________
Front end installation:
1. To begin installation, block the rear tires of the vehicle so
that the vehicle is stable and can’t roll backwards. Safely lift
the front of the vehicle and support the vehicle with a pair of
jack stands. Place a jack stand on both the driver and the
passenger side. Next, remove the front wheels and tires
from both sides.
2. Remove the skid plate from the OE location. Save the
hardware and skid plate.
3. Working on the driver side, remove the hardware that
attaches the front portion of the differential to the OE
mounts. Save the over size washer on the head side of the
bolt. Repeat procedure on the passenger side.