Tuff Country 54070 - Toyota Tundra 07-14 4 lift kit - Manual (Page 4)

4. Locate (2) S10051 sleeves from hardware bag 54070NB..
Also, locate (2) 1/2” x 6” bolts, (2) 7/16” USS flat washers
and (2) 1/2” unitorque nuts from hardware bag 54070NB1.
Working on the driver side, install the new spacer between
the differential and the OE mount and secure using the new
1/2” hardware and the 7/16” USS flat washer on the nut side
of the bolt. Also, make sure to use the OE over size washer
on the head side of the bolt. Repeat procedure on the pas-
senger side. Move back to the new hardware hardware on
the driver and passenger side and add some loctite and
torque to 55 ft lbs.
5. Re-install the skid plate using the OE hardware.
6. Working on the driver side, remove the sway bar from the
OE mount on the frame rail. Save the hardware. Repeat pro-
cedure on the passenger side. Let the sway bar hang.
7. Place a pair of hydraulic floor jacks under the driver and
passenger side lower control arm. Carefully raise up on them
until they come into contact with the lower control arm.
8. Working on the driver side, remove the hardware attach-
ing the ABS line to the upper control arm. The hardware may
be discarded. Repeat procedure on the passenger side.
9. Working on the driver side, remove the (4) upper nuts
holding the strut into the upper strut pocket. Save the hard-
ware. Repeat procedure on the passenger side.
10. Working on the driver side, remove the cotter pin from
the castle nut holding the upper control arm to the knuckle.
The cotter pin may be discarded. Repeat procedure on the
passenger side.