Anthem TLP 1 - Manual (Page 19)

Headphone:
When a headphone plug is inserted into the headphone jack on the front panel, all audio
outputs on the rear panel are muted.
2.8 FM•AM ANTENNAS
To connect the FM antenna, first connect the two antenna wires to the
screw terminals of the 75-ohm to 300-ohm adapter. Then connect the
adapter to the FM ANTENNA connector on the TLP 1. If your local cable
company provides FM service, connect the cable directly to the TLP 1
instead of using the antenna.
To connect the AM loop antenna, press the spring-loaded tabs of the AM
ANTENNA connector, insert the bare ends of the wire from the loop antenna
and release the tabs.
Once the antennas are connected, move each of them around until best
reception is found. For the FM antenna, this will usually be in a “T” formation.
2.9 RELAY TRIGGER
If your other components, such as the power amplifier, have a trigger input, you can
automatically turn them on and off simultaneously with the TLP 1. Connect the RELAY
TRIGGER trigger output from the TLP 1 to the trigger input of your power amplifier, TV
monitor, etc., using a cable with 3.5mm mono mini plugs.
2.10 INFRA RED RECEIVER
An external IR repeater allows the Remote Control to be used from other locations in your
home, for example Zone 2. Once a repeater is wired to a selected room, connect it to the
I.R. RECEIVER input.
13
2. CONNECTIONS AND LAYOUT
continued …
75-ohm to 300-ohm adapter