Setup, 1a. video out config 1, Continued – Anthem D2v 3D User Manual
Page 25
17
Video Output Configurations:
The Statement D2v allows four processed video output configurations, or Through (section 3.6). In most
cases, only one configuration is needed. The rest can be used to match the output refresh rate to source
refresh rates, i.e. 1080p24, 1080p50, and 1080p60 if your display accepts these rates, or with a secondary
display that needs different settings – only one display can be used at a time in this case. Output assignment
by source is explained in section 3.6, and on-the-fly selection is explained at the end of section 4.11.
Once entering Configurations 2 through 4, the menu asks whether or not you want to use the same settings
as Configuration 1 – the factory default is Yes. If different settings are used, the output changes according
to the line that’s highlighted in the VIDEO OUTPUT menu. Highlighting VIDEO OUT CONFIG 1 in the VIDEO
OUTPUT menu then pressing SELECT displays this menu:
Items a. through g. pertain to MAIN output only.
Changes in this menu do not take place immediately to prevent loss of video output as you scroll through
settings. Once you leave this menu, it asks for confirmation – use the
34 buttons to change to Yes, then
press SELECT. To put a change into effect before leaving the menu, press SELECT then confirm.
If using both HDMI outputs and a conflict results when attempting to use two displays at the same time,
ensure that “automation” features that displays sometimes use to determine which of their HDMI inputs
have a signal are disabled. The input selection must remain on the one connected to the processor.
When two displays are connected and powered on, the EDID (handshake info) from the one connected
to HDMI1 is used in regard to Auto selections in the menu above, even if it results in output that the
display connected to HDMI2 does not support.
3. SETUP
continued …
1a. VIDEO OUT CONFIG 1
a. S-VIDEO OSD: NTSC
b.
PREFERRED: HDMI
c. RESL'N: 1280x720p60
d. COLOR SPACE: Auto
e.
DATA: Auto
f.
OUTPUT: Auto
g.LETTERBOX: Black
h.
SYNC: Normal
i.COMPNT2 OUT: Passthru