Anthem D2v 3D - Manual (Page 43)

35
3. SETUP
continued …
EQ (MAIN only):
For sources set to Digital or Anlg-DSP, you can preset low and high frequency levels. This is useful for source
components that have frequency irregularities. After highlighting the EQ line, press SELECT and use the
34 buttons to select LF (low frequency) or HF (high frequency), then use the 56 buttons to adjust. In the
FM/AM Setup/Presets menu, FM and AM can be adjusted separately. The EQ settings in this menu and the
on-the-fly BASS / TREBLE adjustments do not affect each other (see section 4.7).
Bass Manager (MAIN only):
Choose between Movie or Music configuration as set in the Bass Management menu, or Auto-LFE. When
Auto-LFE is selected, the Movie configuration is used if the source contains LFE, and changes to the Music
configuration at all other times. Auto-LFE is recommended when using two bass management configurations
and the same player for DVDs and CDs.
ARC Room EQ (MAIN only):
To disable room correction equalization performed with the ARC-1 microphone kit, change this to Off. If
measurement info isn’t loaded “NA” is displayed.
Dolby Volume (MAIN only):
Dolby Volume makes content with large differences in volume easier to listen to by analyzing it and
intelligently adjusting two things – level and frequency response. It does this continually without causing
pumping and breathing artifacts that are common with traditional dynamic range compressors. In doing so,
the volume setting is taken into account as is our hearing’s declining sensitivity to the lowest and highest
frequencies relative to the midrange as their levels drop. The result is that the perceived frequency response
remains constant while making quieter parts of the content more listenable.
Select Cinema Reference, On, or Off according to the content most often played through the source or
preference. Cinema Reference uses more aggressive leveling, accounting for the difference in reference
level used in movie production from levels in typical music recordings.
Dolby Volume Level (MAIN only):
The leveling amount that Dolby Volume provides can be set from Low to High with nine “medium” steps
between, or Off. Play various sources before finding your preferred setting. When Dolby Volume Level is Off
the frequency response adjustment still applies unless Dolby Volume is also Off.
Half Mode (MAIN only):
Select On or Off. When on, frequency response is not adjusted when playback level is higher than reference
level. This is the recommended setting.
Lip-Sync (MAIN only):
Video can become unsynchronized with audio for different reasons. The Statement D2v’s video processing
is considered to be synchronized with the audio because it only causes a 24 millisecond delay, which is less
than the duration of one frame. If audio is heard before its corresponding image is seen, you can set up to
170 milliseconds of audio delay. To adjust while watching the image see section 4.9.
Example: Set DVD1 Lip-Sync delay to 24 milliseconds.
• Enter the setup menu. Go to SOURCE SETUP and press SELECT.
• Press the 6 button until you reach DVD1 and press SELECT.
• Press the 6 button until you reach LIP-SYNC and press SELECT.
• Use the 34 buttons to move from digit to digit and the 56 buttons to adjust to 24 ms.
• Press BACK to leave the submenu and return to the main menu.