DAVIS Interface Cable Adapter Module - Manual (Page 4)

Page 4 Interface Cable Adapter Module
3. If you plan to mount the ICAM against a wall or other vertical surface, attach the base
to the mounting surface using the #6 x 1” screws. Otherwise, skip this step.
Use two screws (as pictured below) when attaching to a stud. Use three
screws (as pictured below) in any other case. Tighten the screws until the
base is securely fastened to the mounting surface. Do not overtighten.
A TTACHING THE B ASE TO THE M OUNTING S URFACE
4. If you plan to place the ICAM on a horizontal surface, attach an adhesive pad to each
of the four raised circles on the underside of the base. Otherwise, skip this step.
A TTACHING A DHESIVE P ADS