DAVIS DriveRight 600E GPS Wireless Interface Module Manual (8127, 28, 29, 8251) - Manual (Page 7)

5
DriveRight GPS/Wireless Wiring Diagram
Making Connections
The GPS/Wireless Interface Module for DriveRight can be installed with
either the GPS Module, the Wireless On-Board Module or both. The
instructions below assume an installation involving all three modules.
Modify your own installation as necessary.
1. Connect the GPS Module to the GPS/Wireless Interface Module by
plugging the male connector of the GPS Module cable into the socket
labeled “GPS” on the GPS/Wireless Interface Module.
2. Connect the Wireless On-Board Module to the GPS/Wireless Interface
Module by plugging the male connector on the Wireless On-Board Module
cable into the socket labeled “W” on the GPS/Wireless Interface Module.
3. Disconnect the DriveRight 600 E device or optional SmartCard On-Board
Reader cable from the Digital Adapter Cable.
4. Connect the male connector from the GPS/Wireless Interface Module cable
to the female connector on the Digital Adapter Cable.
5. Connect the female connector on the GPS/Wireless Interface Module to the
male connector on the DriveRight 600 E , or optional SmartCard On-Board
Reader cable.
See the diagrams below for properly disconnecting and connecting cables:
Disconnecting Cables:
Hold both cables by their connector housing and pull apart.
The housing of the male connector slides to separate the cables.
Connecting Cables:
Slide
Connector Housing
Hold the female connector and push the male connector from behind the housing, allowing
the housing to slide back. The cables lock together when a connection is made.