GReddy e-Manage Ultimate Installation Manual - Manual (Page 11)

5. How to splice wires
1.Strip the wire as shown.
6. How to install the connectors
2.Wrap the stripped wire together as
shown, and set the crimp in place.
*Crimp is not neccessary if soldering.
3.Crimp or solder the connection. 4.wrap the connection with shrink tube or
electrical tape.
1.Strip the end of the wire and slip
the protective sleeve on.
2.Set the connector over the stripped end.
3.Crimp the inside part with
proper crimping tool.
4.Crimp the out side part and slip the protective
sleeve over the connector.
10