GReddy e-Manage Ultimate Installation Manual - Manual (Page 21)

20
13. Crank & Cam Angle / Water & Intake Temp, Knock Signal
Crank Angle Signal & Cam Angle Signal
• Connect these wires for e-manage Ultimate to recognize the rpm signal from crank and cam
angle signal if there are no tach signal out put from the ecu. Also. by connecting these wires
Ignition timing can be monitored in the data log feature.
If the Crank and Cam angle signal wires are connected to the ecu, e-manage will recognize
the rpm without connecting the rpm signal wire.
IMPORTANT
Knock 1 - 2, Water Temp Signal, Intake Temp Signal
•Connect these wire to the ECU Knock, water temp, or intake temp sensor signal to monitor them
in the data log feature.
•Also by connecting these wire to the water temp and/or intake temp signal the temperature
condition can be set in the software to activate relays with selected relay channels.
Female Connector
Male Connector
Splice
ECU
(Engine Control Unit)
Grey/White (Crank Angle)
Grey/Black (Cam Angle)
G Ne
Female Connector
Male Connector
Splice
ECU
(Engine Control Unit)
Blue/Yellow
(Knock 1 / Water temp)
Purple/Yellow
(Knock 2 / Intake temp)
Kn1/W
Kn2/A
Connector C
Connector C
Connector C
Connector C