GReddy e-Manage Ultimate Installation Manual - Manual (Page 13)

12
8. Wiring Power, Ground, Airflow Meter,Throttle, RPM Signal
Hot-wire airflow meter, Flap type airflow meter, or Pressure sensor
×
ECU
(Engine Control Unit)
Red (12v IG power)
Black (ECU Ground)
Brown (rpm signal)
Green (Airflow Output)
White (Airflow Input 1)
Female connector
Male connector
Splice
Gray (Throttle signal)
×
ECU
(Engine Control Unit)
Red (12v IG power)
Black (ECU Ground)
Brown (rpm signal)
Purple (Airflow Output)
Light Blue (Airflow Input)
Female connector
Male connector
Splice
Gray (Throttle signal)
Karman Vortex type airflow meter
If the Ignition signal, Crank angle signal, or Cam angle signal wire is going to be wired, the
unit does not require the rpm signal wire to be connected to pick up rpm signal.
Important
* Always use the provided connectors or solder all connections.
* Always use the provided connectors or solder all connections.
Connector B
Connector B