Reference, Care and maintenance, Troubleshooting – Aiwa XR-X77 User Manual

Page 14: 14 en

Advertising
background image

14

En

Care and maintenance

Occasional care and maintenance of the unit and the software
are needed to optimize the performance of your unit.

To clean the cabinet
Use a soft and dry cloth. If the unit surfaces are extremely
dirty, use a soft cloth lightly moistened with mild detergent
solution. Do not use strong solvents such as alcohol, benzine
or thinner.

Care of CDs
When a CD becomes dirty, wipe it from the center out with a
cleaning cloth. After playing a CD, store it in its case. Do not
keep it in hot or humid places.

REFERENCE

Troubleshooting

If your unit fails to perform properly, check the following guide
and the relevant sections of the Operating Instructions.

There is no sound
•Are the speakers and AC power cord connected properly?

The unit shut off suddenly
•Possibly a short circuit in the speaker terminals. Disconnect

the AC power cord from the AC outlet and reconnect the
speaker cords correctly.

Erroneous display
•Reset the unit. (See "Resetting the unit" on this page.)

Poor radio reception
•Check antenna connection. Adjust the antenna to find the

best reception.

•Move the unit and antenna away from other electric

appliances and cords.

The CD player works poorly
•Is the disc correctly loaded?
•Is the disc dirty?
•Is the lens affected by condensation? If so, wait

approximately one hour and try again.

Condensation
Moisture may form on the CD pickup lens when:
•The unit is moved from a cold spot to a warm spot
•The heating system has just been turned on
•The unit is used in a very humid room
•The unit is cooled by an air conditioner
When this unit has condensation inside, it may not function
normally. Should this occur, leave the unit for a few hours,
then try to operate again.

Resetting the unit
If an unusual condition occurs in the display window, reset
the unit as follows:
1 Press POWER to turn off the power.

If the power cannot be turned off, disconnect the AC power
cord, then plug it in again.

2 Hold down s and press POWER on the main unit.

Everything stored in memory after purchase is cleared.

Advertising