Monoprice 6815 Graphic Drawing Tablet - Manual (Page 5)

I. General Information
1-2
6. Verifying Hardware and Driver Functions
6.1 Please follow the steps to verify if the wired tablet (Media Wired Tablet) is installed properly ︰ ︰ ︰ ︰
‧ ‧ ‧ ‧ Tablet Features and Accessories .
★ ★ ★ ★ Note: Product configurations may vary and some may not include all the accessories items.
The green LED light on the tablet is the main indicator for hardware operation and
depending on your pen tablet model may be located at a different place that shown in the
above diagram. This LED normally stays off, and will only turn it on or off in response to
various conditions. Watch the state of the LED on the tablet as you go through these test
steps:
1. Tap on any surface with the tip of the pen, or press the left button of the mouse, to
“wake it up” if it has gone into standby mode. A built-in power saving function may have
forced the pen or mouse into the standby mode if either of them is not used for a period
of time.
2. As soon as the pen tablet itself activates, the LED will be light briefly, and will then go
and stay off again.
3. When the tablet detects the presence of the digital pen or mouse, the LED will be
blinked slowly. This happens either when pen tip is hovering or placing within the
working area which above the tablet.
4. When you press a button on the pen barrel, or click on a mouse button, the LED will be
lighted up.
5. Hovering and moving the pen or the mouse in the working area will cause the cursor on
the screen to move accordingly.
★
★ ★ ★ Note: After the tablet’s device driver has been properly installed, a small tablet icon ( )
will appear in the system tray, which is normally at the lower right corner of the
screen.
6
5
10
7
8
9
1
2
3
4