Monoprice 9206 Pan/Tilt/Zoom IP Camera - Manual (Page 30)

Pan/Tilt IP Camera
3.9. DI/DO settings
The video server product provides DI/DO alarm function, a video motion
detection or the digital input signal could trigger the digital output alarm. The duration
of the alarm could also be set. The related settings are explained below:
1. Digital input – can select the normal status of the digital input as either open circuit
or closed circuit. The current status is also displayed.
2. Digital output – can select the normal status of the digital output as either open
circuit or closed circuit. The current status is also displayed.
3. D/O alarm – select the trigger mode of the digital out alarm
A. Motion trigger – if this is selected, the digital output alarm signal will be
active when video motion is detected. The detection sensitivity is set In the
“motion detection” page.
B. D/I trigger – if this is selected, the digital output alarm signal will be active
when the digital input signal is detected..
C. Schedule – if this is selected, the digital output alarm is scheduled
according to the settings of scheduling in section 3.11.
D. Active – force the digital output to be active.
E. Normal–force the digital output to be normal.
4. D/O Alarm duration – this is the digital output alarm duration for each trigger.
Figure 3-14: DI/DO Settings page
30