Monoprice 9888 4-channel Security System Bundle - Manual (Page 23)

4 Cameras & 4 Channel DVR Video Security System Bundle
19
You can see the software version number, whole unit version number, MAC address,
and DVR serial number on this screen.
3.7.3 Motion detection
Enter the Motion Detection screen from Main Menu
→Advanced, as shown below:
MD Channel and STATUS: Each channel has a corresponding switch to determine if
the motion detection is active or not. Press "Enter" to select motion detection "On" or
"Off".
SENSITIVITY: Each channel has a corresponding sensitivity setting (1, 2, 3, or 4), in
which 4 is the most sensitive to any motion detected. Press "Enter" to toggle the option.
MD AREA: Each channel has a corresponding motion detection area setting in which it
will look for motion, while ignoring the rest of the viewing area. Move the cursor to
"SETUP" option of the corresponding channel and press "Enter" to enter the motion
area setup screen. On this screen a red block indicates that motion detection is
activate for that area and a transparent block indicates that motion detection is not
activated, as shown in the example below:
Operating prompt:
Remote control operation: Use "
" (display mode) to select full screen or blank;
Mouse operation: Left-click the mouse and drag the motion box to set the area of
dynamic detection.
Motion detection setup procedures:
A.
Turn "On" the corresponding channel in the "Channel Status" option.
B. Set the sensitivity level as necessary, usually set at 3 or 4.
C. Set the motion area of the corresponding channel in the "Area Setup" option.
D. In the "Recording Mode" screen, set the corresponding channel to "On" in the
"Channel" option.
E. In the "Recording Mode" screen, select "Timing Recording" in the "Recording
Mode" option and click "Record Time Configuration" to enter the Record Time