Agri-Fab 62468 - Manual (Page 12)

12
32. Assemble the hose adapter (nozzle) to the front of
the impeller housing and secure with the three knobs.
Make sure that the switch actuator bracket contacts
the switch on the housing. See figure 18.
FIGURE 21
35. Place the hose hanger rod assembly into the hose
hanger bracket on the impeller housing assembly. See
figure 20.
36. Loop the 25" tarp strap under the hose. Fasten the
hooks to the hose hanger rod. See figure 20.
FIGURE 19
33. Place a hose clamp onto end of hose. Push hose onto
hose adapter (nozzle). Tighten hose clamp onto hose
and hose adapter.
Do not collapse hose adapter
when tightening clamp. See figure 19.
34. The remaining hose clamp will later be used to fasten
the other end of the hose to the deck adapter.
FIGURE 18
HOSE ADAPTER
(NOZZLE)
KNOB
SWITCH
ACTUATOR
BRACKET
37. Assemble the hitch plate to the tractor hitch if:
a. Your tractor has a square (straight) hitch frame,
to help prevent binding.
b. Your tractor has a lightweight hitch frame that
needs reinforcing for towing the Mow-N-Vac.
Use a 1/2" x 1-1/4" hex bolt, a 7/16" flat washer and a
1/2" Nylock hex nut. See figure 21.
FIGURE 20
HOSE ADAPTER
(NOZZLE)
CLAMP
HOSE
25" TARP
STRAP
HOSE HANGER ROD
TRACTOR
HITCH FRAME
(SQUARE)
HITCH
PLATE
TRACTOR
HITCH FRAME
(TAPERED)
1/2" x 1-1/4"
HEX BOLT
7/16" FLAT WASHER
1/2" NYLOCK HEX NUT
ATTACH
MOW-N-VAC
HERE