Troubleshooting – Agri-Fab 62468 User Manual

Page 17

Advertising
background image

17

PROBLEM

POSSIBLE CAUSE(S)

CORRECTIVE ACTION

Engine fails to start

1. Spark plug wire disconnected.

1. Connect wire to spark plug.

2. Safety switch not contacted.

2. Correctly install hose adapter nozzle.

3. Fuel tank empty, or stale fuel.

3. Fill tank with clean, fresh fuel.

4. Fuel shut-off valve closed

4. Open fuel shut-off valve.

(if so equipped).

5. Faulty spark plug.

5. Clean, adjust gap or replace.

Loss of power;

1. Spark plug wire loose

1. Connect and tighten spark plug wire.

operation erratic.

2. Unit running on CHOKE.

2. Move choke lever to OFF position.

3. Blocked fuel line or stale fuel.

3. Clean fuel line; fill tank with clean

fresh gasoline.

4. Water or dirt in fuel system.

4. Disconnect fuel line at carburetor to drain

fuel tank. Refill with fresh fuel.

5. Carburetor out of adjustment.

5. Adjust carburetor.*

6. Dirty air cleaner.

6. Service air cleaner.*

Engine overheats

1. Carburetor not adjusted

1. Adjust carburetor.*

properly.

2. Engine oil level low.

2. Fill crankcase with proper oil.

Too much vibration

Loose parts or damaged

Stop engine immediately and disconnect

impeller.

spark plug wire. Tighten all bolts and nuts.

Make all necessary repairs. If vibration

continues, have unit serviced by an

authorized service dealer.

Unit does not

1. Discharge chute (elbow)

1. Stop engine immediately and disconnect

discharge

clogged.

spark plug wire. Clean inside of housing

and discharge chute (elbow).

2. Foreign object lodged in

2. Stop engine immediately and disconnect

impeller.

spark plug wire. Remove lodged object.

3. Mow-N-Vac cart is full.

3. Empty cart.

TROUBLESHOOTING

*Refer to the engine manual packed with your unit.
NOTE: For repairs beyond the minor adjustments listed above, please contact your nearest authorized service dealer.

Advertising
This manual is related to the following products: