Agri-Fab 62468 - Manual (Page 9)

9
FIGURE 8
13. Flip the cart over so that it rests on its wheels.
14. Assemble the front tongue on top of the rear tongue
using three 3/8" x 3" hex bolts and 3/8" Nylock hex nuts.
See figure 8.
HINT: For easier assembly, support the rear tongue
with a block of wood.
15. Assemble the hitch bracket to the front tongue using two
3/8" x 1-1/4" hex bolts, 3/8" and 3/8" Nylock hex nuts.
Tighten. See figure 9.
16. Secure the hitch pin to the hitch bracket and tongue with
the hair cotter pin. See figure 9.
FIGURE 10
HITCH BRACKET
3/8" x 1-1/4"
HEX BOLT
3/8" NYLOCK
HEX NUT
TONGUE
HITCH
PIN
HAIR
COTTER
PIN
FIGURE 9
17. Release the latch lock lever and tilt the cart bed back.
See figure 10.
18. Assemble the front panel to the cart bed, sliding the
bottom lip of the panel in between the cart bed and the
latch stand bracket. Fasten the panel to the bottom and
sides of the cart bed using six 1/4" x 5/8" hex bolts and
1/4" Nylock hex nuts.
Tighten. See figure 10.
19. Tighten the two bolts that you assembled to the latch
stand bracket in figure 5.
TONGUE
(FRONT)
3/8" x 3"
HEX BOLT
BLOCK
3/8" NYLOCK
HEX NUT
ASSEMBLING VAC PARTS
1/4" x 5/8"
HEX BOLT
FRONT
PANEL
1/4" NYLOCK
HEX NUT
1/4" x 5/8"
HEX BOLT
1/4" NYLOCK HEX NUT
LATCH
STAND
BRACKET