Pure Chronos iDock Series 2 - Manual (Page 12)

8
Setting the alarms
Chronos iDock has four alarms. When activated, an alarm either switches the radio on (if in
standby) and tunes to a digital radio or FM radio station, activates and plays your iPod/Phone
(if inserted) or sounds a beeping alarm tone.
Setting an alarm
1. Press the Alarm button and repeat to select the alarm you wish
to adjust (1-4). This will start the alarm setup.
2. Using the Navigation dial, set the following options for your
alarm:
On/Off: Toggle the alarm on or off
On time: Set the time you want the alarm to start (hours:mins)
Source: Choose DAB (digital radio), FM, iPod or tone as the
sound source you want to use for the alarm
Last Used/Preset: For digital radio and FM source, choose
a station for the alarm to play. ‘Last Used’ will tune to the last
station received by the radio.‘Preset’ lets you select one of your
saved stations
Once: The alarm will sound at the time you have selected and
not repeat
Daily: Every day
Weekdays: Monday-Friday, every week
Weekends: Weekends (Sat-Sun) only
3. Finally, adjust the volume level for the alarm (represented by a
bar on-screen) using the Navigation dial and push to confirm.
You can see which alarms are currently switched on by looking at
the numbered alarm icons on the screen.
Snoozing an alarm
When an alarm is sounding press the Snooze button to silence
the alarm for ten minutes (the default snooze time). The remaining
time left until the alarm sounds again is shown at the bottom of the
display. Hold the
Snooze button down to cancel snooze.
Alarm 4 Setup
Alarm On
Alarm 1 is currently set