Rosendahl nanoclocks GL - Manual (Page 12)

- 12 -
8. Setup Utility
The firmware version installed on your nanoclocks GL is displayed
every time the unit is powering up.
After a LED test (all LEDs light up from left to right) the connection
and output status field LEDs will briefly show the current version (one
digit only, current version is 1).
Please
visit www.rosendahl-studiotechnik.com for upcoming
firmware versions and utility/ monitor programs, coming at the end of
2013.
To boot in firmware update mode, please press and hold 88.2 and
96 kHz sample rate buttons while connecting the unit to mains.
If in update mode, the 88.2 and 96 kHz buttons are continously
illuminated.
Now start the setup software and select the midi I/O ports. In
Windows XP you must select the USB audio device, Vista or
Windows 7 will list NanoclocksGL.
Press the "Update firmware" buttom to start the update process.
Do not disconnect the unit during firmware programming.
nanoclocksGL is a so called "device class compliant USB Audio
Device" and does not need a driver installation. Windows XP or later
as well as Mac OS X provide generic USB audio drivers.
If you plug in the unit for the first time, Windows will find the new
hardware and install its generic drivers automatically.
If nanoclocksGL isn't detected by Windows you may need to
configure the Windows Device Manager to show all hidden and
ghosted devices to evaluate the problem and possibly remove/delete
obsolete devices.
Find help at Microsoft support how to display ghosted devices in
Device Manager….