Sol TP Series Top of Pole Mount Lighting - Manual (Page 17)

17 rev.1011 MKTG-IM-TP-12-002
Installation and Owner’s Manual | TP Series Solar LED Lighting System
3.3 Preventive Maintenance and Service
Obstructions
Obstructions (including tree branches) must not shade the solar panel(s). Check for and
remove any obstructions in the vicinity of the solar panel(s) once every three months.
Solar Panel Cleaning
The solar panel(s) should be cleaned periodically to insure optimum performance.
Solar panels can get very hot when the sun is out. It is advisable to clean solar
panels during the early morning hours.
1. Using a non-streaking window cleaner and a soft cloth, thoroughly wipe down
the solar panel(s) to remove any dirt and grime that may have accumulate. A
plastic scraper may also be needed for removing bird droppings.
2. Dry the solar panel(s) with a soft clean cloth.
3. Repeat Steps 1 and 2, if necessary, until all dirt and grime have been removed.
Fuse Replacement
If the TP Series lighting system does not operate, replace the fuse.
If the fuse needs to be replaced, be sure to also check operation of the
controller (see page 15).
1. Open the battery box.
2. Remove the fuse cover on the fuse holder.
3. Remove the existing fuse, insert the new fuse, and replace the fuse cover.
4. Test the system (see page 15).
5. Close the battery box.
LED Fixture Replacement
1. Remove the LED fixture from the arm. See page 10 for details.
2. Install the new LED fixture, following the procedure on page 10.
The LED in the fixture is not serviceable. The entire LED fixture assembly
must be replaced.
3. Test the system (see page 15).