Audiovox HOMEBASE DPF710K - Manual (Page 11)

DPF710K 11
Installation (Cont)
To remove and replace the battery, proceed as follows:
1. Lay the homebase on a flat surface with the front panel facing up.
2. Grasp the center of the front panel at the top and bottom edge and bow the panel out until it clears the left side
by the control buttons. Remove the panel to reveal the battery compartment cover.
3. With your thumb, press the cover in the direction indicated by the arrow until it disengages. Lift off the cover.
4. Carefully remove the battery.
5. Insert the battery in the compartment paying special attention to battery orientation (+ side facing up).
6. Replace the battery compartment cover by first engaging the right-hand tabs in the slots. Then press down and
slide the cover to the left to secure the cover in place.
7. Replace the front panel by engaging the right side under the protruding lip; then slightly bow the panel out and
slide the left side under the lip by the control buttons.
8. The battery backup feature should now be operational.
A type CR2032 battery is installed in a compartment behind the front
panel of the homebase. If the unit is being used for the first time, the
battery must be activated. A plastic insulator prevents contact with the
battery terminals. This insulator must be removed for the calendar/
clock backup functions to operate. To remove the insulator, simply pull
out the plastic tab extending from the right side of the unit below the
marker pen.
Internal Battery Activation and/or Replacement
Post-It
®
note pad
storage
Marker pen
storage
Pull out this tab
(“REMOVE THIS
TAB”) completely
to enable battery
operation
Protruding Lip
(Right Side)
Battery Compartment
Button-Type Battery
(CR2032)
Battery Compartment
Cover
homebase Front Panel
Protruding Lip
(Left Side)
Control Buttons