Audiovox HOMEBASE DPF710K - Manual (Page 8)

8 DPF710K
Installation (Cont)
homebase Countertop Installation
1. Find a suitable location on the countertop adjacent to an AC wall outlet.
2. Connect the power adapter plug to the DC input connector at the rear of the homebase.
3. Choose the direction of the adapter wire in reference to the AC wall outlet. Place the DC wire in the correspond-
ing wire notch.
4. Check the amount of wire required to reach the AC outlet. Spool excess wire on the four posts inside the rear
cavity of the homebase.
5. Attach each angle mount bracket to the homebase by lining up the individual angle mount bracket upper
mounting tab with the associated homebase mounting hole.
6. Push each angle mount bracket towards the top of the homebase until the upper mounting tab engages the
mounting hole slot; when the bottom of the angle bracket contacts the homebase, the tab on the bottom of the
angle bracket snaps into place.
7. Place the homebase in the desired location.
DC Input Connector
Power Adapter
Wire Notches
Angle Bracket Mounting Holes
Wire Post(s)
Angle Mount
Brackets
homebase
Unit
Bracket Upper
Mounting Tabs
Bracket Lower
Mounting Tabs