Audiovox HOMEBASE DPF710K - Manual (Page 7)

DPF710K 7
Installation
homebase Refrigerator Installation
1. Remove the protective backing from one side only of the two adhesive pads and position them on the back of the wall
mount bracket as shown.
2. Clean the homebase mounting area on the refrigerator with isopropyl alcohol; do not use a glass cleaner.
3. Place the wall mount bracket in the desired area and level the top of the bracket.
Note: Before removing the remaining protective backing from the two adhesive pads, be sure of the homebase
mounting location as the adhesive pads are not designed to be removed and repositioned once they are
applied to the refrigerator surface.
4. Remove the protective backing from the two adhesive pads, line up the top of the bracket, and firmly press and hold the
bracket in place on the refrigerator surface to ensure the pads adhere securely.
Note:
3M™ recommends waiting 24 hours for maximum adhesion prior to mounting your homebase to the mounting
bracket.
5. Connect the power adapter plug to the DC input connector at the rear of the homebase.
6. Choose the direction of the adapter wire in reference to the AC wall outlet. Place the DC wire in the corresponding wire
notch.
7. Check the amount of wire required to reach the AC outlet. Spool excess wire on the four posts inside the rear cavity of
the homebase.
8. Attach the homebase to the bracket by lining up the homebase bracket mounting holes with the wall bracket mounting
tabs, and slide the homebase down until the mounting tabs engage the mounting hole slots.
9. Cover the power adapter wire with the clear, black or white wire cover; seal the cover using the double-sided tape and
dress the wire, adhering it to the refrigerator surface.
Caution: The power adapter wire routing follows the right angle contour of the refrigerator door. Do NOT cover the DC power
adapter wire using the double-sided tape after the 90 degree transition from the front refrigerator surface to the side
surface and for at least one inch rearward of the refrigerator seal. This will allow movement of the power adapter wire as
the refrigerator door opens and closes.
Adhesive
Foam Pads
DC Input
Connector
homebase Bracket Mounting Holes
Wall Mount Bracket
Power Adapter
Wire Notches
Wire Post(s)
Power Adapter
Wire Notch
Refrigerator
Door Seal
homebase
Wire Cover
Wire Cover
1 inch
DC Power Wire
Refrigerator Door Front Surface
See Step 9
Caution
Below