ASA Electronics Universal Remote - Manual (Page 3)

3
1. Power TBXPAL On
1-1 Feed the “+12VDC” power supply to TBXPAL’s “POWER INPUT” socket.
2. Set TV source to A/V input
3. Scan Channels and Auto-programming
3-1 Press the [ A /P ] button on the remote.
Tuner will scan all channels in the “AIR” and “CATV” modes and memorize
channels with PAL TV signal in the modes for “AIR” and “CATV”.
It takes 45 and 75 seconds to scan in the “AIR” and “CATV” modes respectively.
4. Adjust the volume of Audio Output
4-1 Press the [ VOL + ] button to increase the audio volume.
4-2 Press the [ VOL - ] button to decrease the audio volume.
5. Adjust the TBXPAL ’s System Settings
Press [ MENU ] button to activate the setting menu.
5-1 The 1 st menu item is “TUNER MODE”. Press [ ► ] or [ ◄ ] to browse and select
a tuner mode from “AIR” and “CATV”.
5-2 Press [ MENU ] 2 nd time. The 2 nd menu item is “AUDIO OUTPUT”.
Press [ ► ] or [ ◄ ] to browse and select an option from “STEREO”, “MAIN”,
“SUB” or “MONO” depending on the audio signals available in the TV signal.
5-3 Press [ MENU ] 3 rd time. The 3 rd menu item is “CHANNEL SKIP”.
Press [ ► ] or [ ◄ ] to turn the skip mode “ON” or “OFF”.
When skip mode is “ON”, pressing [ CH+ ] or [ CH- ] will go to next or previous
broadcasted channel.
When skip mode is “OFF”, pressing [ CH+ ] or [ CH- ] will increase or decrease
the channel by one.
5-4 Press [ MENU ] 4 th time. The 4 th menu item is “RESET”.
Press [ ► ] or [ ◄ ] to restore the factory’s default value for above settings, and
remove programmed channels with PAL TV signal for “AIR” and “CATV”
modes.
All settings are saved to non-volatile memory when OSD disappears.
( Approximate 6 seconds for storage)
6. Searching a channel and Watching
6-1 Press [ CH+ ] or [ CH- ].
6-2 Directly Input a channel number by pressing [ 0 ] ~ [ 9 ] buttons.
Basic Operations