Vaisala DMT346 - Manual (Page 86)

User's Guide _______________________________________________________________________
86 ___________________________________________________________________ M210762EN-G
Communication Protocol
When a Telnet connection is established via the LAN or WLAN
interface, the session has the same communication mode, run interval,
poll address and echo settings as the serial port (user port) session would
have.
These settings can be changed using the display/keypad, using the serial
line (user port or service port), or on-the-fly during the Telnet session.
The display menu path to the Communication Protocol settings is:
Main Menu
► Interfaces ► Network Interface ► Communication
Protocol.
The commands for changing the settings are SMODE, INTV, ADDR,
and ECHO.
Web Configuration for LAN and WLAN
The LAN and WLAN interfaces both have a web configuration page that
is accessible using a browser. If you have not disabled the page from the
network settings, you can access it with a web browser at the IP address
of the interface. You can check the currently assigned IP address of the
interface from the device information screens (see Device Information on
page 106), or from the serial line by issuing the net ? command.
When accessing the web configuration page, you must first log in.
Username: user
Password: vaisala
The web configuration page provides similar network configuration
options as the serial line and the display/keypad. It also has additional
options for advanced users. For example, there are more options for
securing the wireless network.
If these additional options are used, they will appear as custom
configurations when viewed from the serial line or the display/keypad.