HighPoint RocketRAID 2210 - Manual (Page 81)

Mac OSX Driver and RAID Management Software
4) The installer will ask you to select a destination for the driver. Make sure to
select the boot Volume - the driver must be installed to /System/Library/Exten-
sions/ folder in order to function properly.
5) Click the “Install” button.
You will be prompted: “clicking the install button will install a basic installation of
the software package on your selected volume”. Confirm the prompt to install
the software package.
6) You will then be notified that a reboot is needed to install the software. Click
“Continue Installation”.
7) The driver will then be installed into the system. Click “Restart” to restart the
system.
After the system restarts, you can use a web browser to configure the controller and
setup RAID arrays. Use MacOSX Disk Utility to create partitions the RAID arrays.
Web RAID Management Interface
Note: To use the web-based RAID management interface, a web browser with XML
support is required, e.g. Internet Explorer 6.0, Mozilla or FireFox.
To run the management interface, start your browser and enter the following URL
address:
https://localhost:7402
If you are managing a remote system please change “localhost” to the server’s host
name or IP address.
7-2