AMETEK 1990 DN DeviceNet Resolver Interface Module User Manual
Page 6
6
1080 N. Crooks Road • Clawson, MI 48017 • 800.635.0289 • 248.435.0700 • Fax 248.435.8120 • www.AMETEKAPT.com
3.3.3: Position Offset
The indicated position of the resolver can be
changed to synchronize or “zero” the resolver to the
machine it is attached to. The resolver position can
be changed by moving the resolver at the desired
position and writing the desired indicated position to
attribute 1 of the Position Object. All setpoints will be
based on this offset position. A valid position value
can range between, and include, zero and the scale
factor. (i.e. 0 < position < scale factor).
3.3.4: Setpoints
As indicated the DeviceNet Resolver has 8
programmable setpoints. Each setpoint is
individually programmed through the Parameter
Object. Each setpoint has an “On Position” value
and an “Off Position” value. All setpoint defaults are
set to 0.
Each setpoint has only one “On” and
one “Off” per revolution.
NOTE: The setpoints can be changed after the
scale factor has been established. The setpoints
cannot be configured outside the scale factor range.
Setpoint 1 “On” Position
Set
Parameter Instance 5 Attribute ID 1 Desired On Position Value
Setpoint 1 “Off” Position
Set
Parameter Instance 6 Attribute ID 1 Desired Off Position Value
Setpoint 2 “On” Position
Set
Parameter Instance 7 Attribute ID 1 Desired On Position Value
Setpoint 2 “Off” Position
Set
Parameter Instance 8 Attribute ID 1 Desired Off Position Value
Setpoint 3 “On” Position
Set
Parameter Instance 9 Attribute ID 1 Desired On Position Value
Setpoint 3 “Off” Position
Set
Parameter Instance 10 Attribute ID 1 Desired Off Position Value
Setpoint 4 “On” Position
Set
Parameter Instance 11 Attribute ID 1 Desired On Position Value
Setpoint 4 “Off” Position
Set
Parameter Instance 12 Attribute ID 1 Desired Off Position Value
Setpoint 5 “On” Position
Set
Parameter Instance 13 Attribute ID 1 Desired On Position Value
Setpoint 5 “Off” Position
Set
Parameter Instance 14 Attribute ID 1 Desired Off Position Value
Setpoint 6 “On” Position
Set
Parameter Instance 15 Attribute ID 1 Desired On Position Value
Setpoint 6 “Off” Position
Set
Parameter Instance 16 Attribute ID 1 Desired Off Position Value
Setpoint 7 “On” Position
Set
Parameter Instance 17 Attribute ID 1 Desired On Position Value
Setpoint 7 “Off” Position
Set
Parameter Instance 18 Attribute ID 1 Desired Off Position Value
Setpoint 8 “On” Position
Set
Parameter Instance 19 Attribute ID 1 Desired On Position Value
Setpoint 8 “Off” Position
Set
Parameter Instance 20 Attribute ID 1 Desired Off Position Value