High Country Tek MVP-R Series - Manual (Page 4)

021-MVP-R Rev A MVP-R User Manual 4
Copyright © High Country Tek, Inc. – 2013
MVP-R
Ramping Controller
Product Application Guidelines
ALWAYS do the following

FULLY read this manual and accompanying data sheets BEFORE starting.

Isolate this unit from all other equipment BEFORE any form of welding.

Isolate the controller from ANY form of battery charging or battery boosting.

Be aware of the electrical & mechanical connections, and the expected reactions of the equipment.

Operate the units within the temperature range.

Use the correct tools to do the job (i.e. P.C., software) etc.

Separate High Voltage AC cables from Low Voltage DC signal and supply cables.

Make sure power supply is CORRECT, ELECTRICALLY CLEAN, STABLE, and rated for the full load.

Make sure the controller output voltage & current is compatible with the equipment.

All unused wires / terminals should be terminated safely.

Ensure ALL connectors have no unintended SHORT or OPEN circuits.

Ensure ALL connectors are wired correctly, secure, locked in place and fully connected.

Disconnect or connect wires to or from this unit only when the power supply is disconnected.

Use adequate screening in areas of intense Radio Frequency fields.

Ensure ALL work areas are clear of personnel before operating the controller.

Follow and abide by local and country health & safety standards.