Superweeder set-up, 16' hitch assembly, Section 4 – Summers 3-Rank Superweeder User Manual
Page 27: Assembly: 3-rank superweeder, Set-up instructions -1 - 4-14
4-1
SECTION 4 – SET-UP INSTRUCTIONS — SUPERWEEDER
The machine should be placed in an area that allows ample room for assembly in field position (See Fig. 1).
CAUTION: For safety purposes, block equipment while working on it.
Refer to illustrations and parts listing on pages 8-2 through 8-20 and follow these steps when assembling.
16’ HITCH ASSEMBLY
HITCH, HUBS AND WHEELS
Mount axle plates with spindles down for 11L tires and with spindles up for 14L tires. Mount hitch wheels and tires and install
hitch jack.
CENTER WING DRAWBAR TUBES FOR 16’ HITCH
Attach center tube to hitch using (2) 1-3/16” x 7-1/4” pins and secure with 7/16” x 3” bolts and locknuts. Attach wing tubes to
center tube knuckles using 1-1/4” x 7” pins. When in field position, the locking collar is on top. Insert a 7/16” x 3” bolt through
the locking collar and hole in the top of each pin and secure with locknut. Secure pin with 1” flat washer and 1” NC lock jam
nut.
IMPORTANT: Be sure to install wing tube spindles with spindle down in field position.
Mount support wheels and tires. Do not mount transport wheel assemblies until lift arms are positioned.
NOTE: Wing tubes equipped with ADD (Adjustable Double Disk) drawbar are assembled at the factory for left and
right applications. Each wing tube is marked with a large L or R for left and right identification.
Fig. 1