Electrix Warp Factory - Manual (Page 15)

RECORDING PERFORMANCES TO A SEQUENCER
E lectrix products are real performance products. They have been designed with this in mind
and can accurately transmit and receive your performance through MIDI. Every knob and
every switch can be automated. To do this, simply connect the WarpFactory to a sequencer.
WarpFactory has MIDI Control Change messages assigned to all of its functions. Any
performance will show up in the sequencer as MIDI CC’s (Control Change Messages).
Note that a press and hold of the bypass button will dump the present state of the controls.
MIDI CC #116 will request a dump of state.
Setting the MIDI channel: On the back of the WarpFactory is a small rotary switch labeled MIDI
channel. Use it to set the Transmit / Receive channel of WarpFactory.
Function Transmitted Recognized Remarks
Basic Channel Selectable 1-16 1-16
Mode Default X Mode 3
Messages X X
Note Number X X
Velocity Note ON X X
Note Off X X
After Touch X X
Pitch Bender X X
Control Change 102 0 0 Gender 4-124 (64 = no gender)
103 0 0 Q 0 - 127
104 0 0 Order 2-24
105 0 0 Noise Level 0-127
106 1 0 0 Waveform Pitch 0-125 (0 = off)
107 0 0 Freeze ( 0-63 off 64-127 = on)
108 0 0 Warp Band (0-63 low 64-127 - high)
110 2 0 0 Source Kill 0-90
111 0 0 Effect Mix 0-127
112 3 0 0 Bypass (0-63 off 64-127 on)
113 4 0 0 Ess On/Off 0-3
115 5 0 0 Formant input select 0-2
116 0 0 Dump request
Program Change X X
System Exclusive X X
System Common Song Position X X
Song Select X X
Tune Request X X
System Real Time Clock X X
Commands X X
Aux Messages Local On/Off X X
All notes Off X X
Active Sensing X X
System Reset X X
Notes
1. 0=mute. Values 1 to 125 increase pitch in 0.25 semitone steps from FO - C3.
2. The front panel Source Kill switch toggles between values of 20 and 90. CC edit allows fine threshold control between 0 and 90.
3. When bypass is held for 2 seconds, it will send CC values for all controls. This will ensure that all parameters are stored
during recording even when only one control is swept.
4. Will select Ess value only when Mic or Line input is selected. When formant input is set to auto, this CC will ahve no effect.
If Ess value 1 - 3 is received when Line is selected for formant input, the formant input selected will change to Line (voice).
5. Selects formant input. 0 = mic, 1= line, 2 = auto.
Mode 1: OMNI ON, POLY
Mode 2: OMNI ON, MONO 0: YES
Mode 3: OMNI OFF POLY Mode 4: OMNI OFF MONO X: NO
4.2 MIDI IMPLEMENTATION CHART
4. MIDI
4.1