Siemens TE503209RW - Manual (Page 12)

8
de en
Menu settings
You can adapt the appliance to your indi-
vidual needs in the menu settings.
1. Hold the
e
off / j button (12) down for
at least 3 seconds.
2. Press the
e
off / j button (12) repeat-
edly until the required menu item ap-
pears in the display.
3. Select the required setting with the up-
per rotary knob (14).
4. Conirm by pressing the start button
(10).
To leave the menu without making any
changes, turn the rotary selector to Exit
and press the start button (10).
You can set the following:
Shut off : Here you can set the time span
after which the appliance automatically
switches off following the last drink prepara-
tion. A time between 15 minutes and 4
hours can be set. The default time is 1 hour,
but this can be shortened to save energy.
Filter : Here you can set whether a water
ilter is being used. If a water ilter is not
being used, turn the setting to No / Old .
If a water ilter is being used, turn the set-
ting to Activate filter . New water ilters
have to be rinsed before use (see “Water
ilter” on page 7).
Start Calc‘n‘Clean : The service pro-
grammes ( Calc‘n‘Clean / descaling /
cleaning ) can be selected manually here.
Press the start button (10) and run the se-
lected programme (see “Service
Programmes” on page 14).
Temp. : The brewing temperature ( high /
middle / low ) can be set here.
Language : The display language can be
set here.
Water hardness : The water hardness
setting can be adjusted on this appliance. It
is important to set the water hardness
correctly, so that the appliance indicates
accurately when the descaling programme
should be run. The factory setting for the
water hardness is 4.
You can check the water hardness using
the enclosed test strip or by asking your lo-
cal water supplier.
Dip the test strip briely in water, gently
shake off any drips, and check the result
after one minute.
Level Water hardness
German (°dH) French (°fH)
1
2
3
4
1-7
8-14
15-21
22-30
1-13
14-25
26-38
39-54