Siemens HV541ANS0 - Manual (Page 24)

24
5. Remove the middle panel.
Note: The middle panel is kept in place with rubber bushings
rather than retaining pins.
Clean the panels with glass cleaner and a soft cloth.
:
Risk of injury!
Scratched glass in the appliance door may develop into a
crack. Do not use a glass scraper, sharp or abrasive cleaning
aids or detergents.
Fitting the door panels
1. Reinsert the middle panel.
Note: Make sure that the panel is seated correctly. All rubber
bushings must lay flat against the outer panel.
2. Reinsert the inner panel.
Note: All four fastening pins must engage in the holders
provided for them.
3. Refit the oven doors.
Removing and inserting the hook-in racks
You can remove the hook-in racks for easier cleaning.
Removing the hook-in racks
The hook-in racks are each fixed to the side panels of the
cooking compartment at three points.
1. Grip the front of the hook-in rack and pull it to the middle of
the cooking compartment.
The front hook of the hook-in rack will release from the hole.
2. Fold out the hook-in rack further and pull it from the rear
holes of the side panel.
3. Hold the catalytic cooking compartment panel in place.
4. Remove the hook-in rack from the cooking compartment.
Inserting the hook-in rack
1. Hold the catalytic cooking compartment panel in place.
2. Insert the hooks of the hook-in rack into the rear holes in the
side panel.
3. Press the front hook of the hook-in rack into the hole.
Troubleshooting
Malfunctions often have simple explanations. Please read the
following notes before calling the after­sales service.
:
Risk of electric shock!
Incorrect repairs are dangerous. Repairs may only be carried
out by one of our trained after-sales engineers.
Incorrect repairs may result in significant risk to the user.
D E
Problem Possible cause Notes/remedy
The appliance
does not work.
Circuit breaker
faulty.
Look in the fuse box and
check that the circuit
breaker for the cooker is in
working order.
Power cut Check whether the kitchen
light works.
The oven can-
not be switched
off.
The electronics
are faulty.
Switch off the circuit
breaker. Contact the after-
sales service.
The clock dis-
play flashes.
Power cut Reset the clock.
The oven does
not heat up.
Circuit breaker
faulty.
Check the circuit breaker
and replace if necessary.
The function
selector has not
been set.
Set the function selector.
The door glass
is broken.
Switch off the appliance.
Contact the after-sales ser-
vice.
Fruit juice or
albumen stains
on enamelled
surfaces.
Moist cake or
meat juices.
Harmless change in the
enamel, cannot be
removed.
Problem Possible cause Notes/remedy