Phottix Mitros for Nikon - Manual (Page 12)

12
En INSTRUCTION MANUAL
- When using wireless bounce flash, please ensure the Slave flash Wireless
Signal Receiver Area faces toward the Master flash.
- When using only one flash set Wireless Mode to “OFF”.
Transmission channels
The Phottix Mitros+ OP Tx/Rx Wireless system has four transmission channels: 1,
2, 3 and 4. Signals from the OP Tx (Master) flash are sent to OP Rx (Slave) flashes
on these channels. If Master and Slave flashes are set to different channels the
Slave flashes will not fire.
Using OP Tx/Rx Wireless Triggering
With a flash in OP Tx (Master) mode on the camera and remote flashes in OP Rx
Slave mode, pressing the shutter button will fire the OP Tx (Master) flash (if set to
fire the flash) and flashes set to OP Rx (Slave) mode within the range of the OP Tx
(Master) flash. The camera and flash will meter the scene and fire flashes in TTL
mode to properly expose the scene.