U.S. Products TORRENT - Manual (Page 5)

5
RECOVERY TANK:
(refer to Figure 2)
Pre-Filter: 800 micron polyester mesh bag with quick-change cord lock. This filter hangs inside the tank
from the recovery hose inlet piping. Check the pre-filter before operation and clean as required.
Stainless Steel Filter: 50-mesh filter screws into base of recovery tank. Inspect daily and clean as
needed.
Float Valve: Located on the back wall in recovery tank, it automatically controls dump pump when
switch is in ON position. Before each use, inspect the float to ensure it is in the proper
position and clear of debris that would interfere with free operation.
Recovery Tank Dump Hose: Located on the rear of the recovery tank. Use this hose to manually
drain the remaining recovered solution from the tank and during tank cleaning.
FIGURE 2
Vacuum Motor Cover
Recovery Tank Lid
Latch
Pressure
Adjustment
Cap
Amp Meter
Castor
High Pressure
Pump Inlet
Pressure Gauge
Oil Level View Port
Auto-Dump
outlet
Wheel
Hour Meter
Power Cord
Dual Cord
Sensor Light
Switch Plate
Drain Hose