U.S. Products TORRENT User Manual
Page 7
7
AUTO-FILL:
Without Chemical Injection:
Simply connect one end of the water supply hose to a convenient water supply, and connect the other
end to the water inlet fitting on the machine. NOTE: hot water cleans better than cold water. When
all set-up and ready to begin cleaning, turn on the water supply.
With Chemical Injection:
Chemical Supply:
Place the container of concentrated chemical cleaner --
use a product with a pH between 6 and 10 to
avoid premature pump wear, which would void the warranty -- in a sink or near the water supply.
Insert the end of the clear tubing with the foot valve attached into the chemical container.
NOTE: the ceramic weight at the foot valve will keep the valve at the bottom of the container.
Connect the chemical injector to the threads on a water supply (utility sink, garden hose). Bring the
clear tubing from the chemical container to the metering tip.
COLOR
TAN
ORANGE
TURQUOISE
PINK
GRAY
OZ/GAL
0.45
0.636
1.1
1.38
4.36
METERING TIP
FLOW RATES
The solution
hose to the
machine
attaches here
Metering Tip
Connects to
the water
source
CHEMICAL INJECTOR & WATER CONNECTION ASSEMBLY
Direction of flow
The metering tip is replaceable. Change the metering tip to adjust the amount of chemical used per
job. Refer to the flow rate chart above and included with your metering tips.
To change the metering tip, carefully unscrew the tip that is installed and replace it with the tip of your
choice. Put the tip you removed in a safe and clean location.
NOTE: the Torquiose tip is installed at the factory.
NOTE: the Torquoise tip
is installed at the factory
CHEMICAL INJECTOR
Metering Tip