Ab c – AMICA ZWM416W EN User Manual

Page 21

Advertising
background image

19

Connect the cold water supply hose to a threaded 3/4(inch) connector and make sure that it is

fastened tightly in place.
If the water pipes are new or have not been used for an extended period of time, let the water

run to make sure that the water is clear and free of impurities. If this precaution is not taken,
there is a risk that the water inlet can get blocked and damage the appliance.

The water supply to the appliance can also be connected to the house hot water line

(centralized system, heating system),as long as it does not exceed a temperature of 60 C.

In this case, the wash cycle time will be shortened by about 15 minutes and the wash

efficiency slightly reduced.

The connection must be made to the hot water line following the same procedures as those
for the connection to the cold water line.

Position the appliance in the desired location. The back should rest against the wall behind it, and the sides, along the adjacent

cabinets or wall. The dishwasher is equipped with water supply and drain hoses that can be positioned to the right or the left to

facilitate proper installation.

Improper connection of the equipment-grounding conductor can result in a risk
of electric shock. Check with a qualified electrician or service representative if you
are in doubt whether the appliance is properly grounded. Do not modify the plug
provided with the appliance; If it is not fit for the outlet. Have a proper outlet installed
by a qualified electrician.

„

In order to avoid that there is more water staying in the inlet hose,

please close the hydrant after using.(For the models: no safety inlet hose.)

Insert the drain hose into a drain pipe with a minimum diameter of 4 cm, or let it run into the sink, making sure to avoid bending

or crimping it. Use the special plastic support that comes with the appliance. The free end of the hose must be at a height
between 40 and 100cm and must not be immersed in water.

Once the appliance is positioned,adjust the feet (screwing them in or out) to adjust the

height of the dishwasher, making it level. In any case ,the appliance should not be inclined

more than 2 .

φ 40mm

Drain hose hook

Drain pipe

Front

A

B

C

Close the drain hose hook to the counter

Counter

Advertising