AMICA ZWM416W EN - Manual (Page 22)

20
Aquasafe
The Aquasafe System is a safety valve system, preventing you from water leaks. If the water inlet
hose starts to leak during a wash cycle, the safety valve cuts off the running water. Do not
immerse the water inlet hose or the safety valve in water, because the electrical cable for the
safety valve is in the double-walled water inlet hose.
If water inlet hose or the safety valve is damaged, remove the main plug immediately.
Do not enlarge or shorten the inlet hose because it contains electric parts.
●
Attention
●
Start of dishwasher
The followings should be checked before starting the dishwasher.
1 Whether the dishwasher is level and fixed
2 Whether the inlet valve is opened
3 Whether there is leakage at the connections of the conducts
4 Whether the wires are tightly connected
5 Whether the power is switched on
6 Whether the inlet and drain hoses are knotted
7 All packing materials and printings should be taken out from the dishwasher
After installation, please put this manual into the bags of printings. The content
of this manual is very helpful to the users.
Water Outlet
Connect the water drain hose. The drain hose must be correctly fitted to avoid water leaks.
Ensure that the water inlet hose is not kinked or squashed.
Extension Hose
If you need a drain hose extension, observe to use a similar drain hose.
It must be no longer than 4 metres; otherwise the cleaning effect of the dishwasher could be reduced.
Syphon Connection
The waste connection must be at a height of between 50 cm (minimum) and 100 cm (maximum)
from the bottom of the dish. The water drain hose should be fixed by a hose clip.