AMICA ZWM416W EN User Manual

Page 24

Advertising
background image

22

If overflow occurs, turn off the main water supply before calling a service. If there is water in the base pan because of an overfill
or small leak, the water should be removed before restarting the dishwasher.

Combination of soft

water and too much
detergent

Use less detergent if you have soft water and select a

shortest cycle to wash the glassware and to get them clean.

Tea or coffee stains

using a solution of 1/2 cup of bleach and 3 cups warm water
to remove the stains by hand.

You have to wait for 20 minutes after a cycle to let the heating

elements cool down before cleaning interior; otherwise, burns
will happen.

Iron deposits in water

can cause an overall film

You have to call a water softener company for a special filter.

Hard water minerals

To clean the interior, use a damp sponge with dishwasher
detergent and wear rubber gloves. Never use any other cleaner

than dishwasher detergent for the risk of foaming or suds.

Dial is not in the

position

OFF

Turn the Dial to

OFF position and slide the door latch to the

left.

Dishes block detergent

cups

Re-loading the dishes properly.

Normal phenomenon

There is some steam coming through the vent by the door
latch during drying and water draining.

Aluminum utensils have

rubbed against dishes

Use a mild abrasive cleaner to eliminate those marks.

'

This is normal

A small amount of clean water around the outlet on

the tub bottom keeps the water seal lubricated.

Be careful not to overfill the rinse aid dispenser.

Spilled rinse aid could cause oversudsing and lead

to overflowing. Wipe away any spills with a damp cloth.

Make sure the dishwasher is level.

Overfill dispenser or rinse

aid spills

Dishwasher isn t level

'

Damaged or detective

drain pump

Replace the drain pump

Longer inlet time.

Faucets is not opened.

Longer draining time.

The installation position of the drain pipe is too high.

Longer heating time,

but not reaching required temperature

Malfunction of temperature sensor or of heating element.

Overfilled.

Too much inlet water. .

Failure of temperature sensor

Short circuit or break of temperature sensor

Open circuit or break of temperature sensor

Failure of temperature sensor

Advertising