American Dryer Corp. MLG31PCA - Manual (Page 34)

30
SECTION IV
OPERATING INSTRUCTIONS
A. STARTING THE DRYER
1. Coin Dryers
The dryer is available for use when the light emitting diode (L.E.D.) display reads “FILL” and/or the
amount needed to start the dryer (i.e., “25”). Once the load has been put into the dryer and the main door
is closed, start the dryer as follows:
a. Insert the proper number of coins into the coin acceptor. Once the correct “Amount To Start” has been
inserted, the L.E.D. display will read “PUSH” ... “tEnP.”
b. Determine fabric setting (selection). Setting “HI TEMP” is the high temperature range, “PERM PRESS”
is the medium temperature range, and “LO TEMP” is the low temperature range.
Once the fabric temperature setting (selection) has been determined, you start the dryer by pressing the
fabric setting key for the basket (tumbler) being used (i.e., “LO TEMP” setting for the upper basket
[tumbler]).
c. The dryer will now start, and the L.E.D. display for the basket (tumbler) selected will read the setting
and the time vended (i.e., “LO 10”).
d. The cycle time will count down until the drying and cooling cycles are completed.
e. Upon completion of the drying cycle and cooling cycle, the dryer will shut off, the tone (buzzer) will
sound for 5-seconds, and the L.E.D. display will read “donE.”
NOTE: If the Anti-Wrinkle program is active, the L.E.D. display will remain reading “donE,” and the
Dual Microprocessor Controller (DMC) computer will proceed through the Anti-Wrinkle
program until the maximum “Active Guard Time” has expired or until the main door is opened,
whichever comes first.
NOTE: If the Anti-Wrinkle program is not active or in use, the L.E.D. display will read “donE” until
the main door is opened, at which time, the L.E.D. display will read “FILL” and/or the
“Amount To Start.”
f. Notes
1) The dryer basket (tumbler) can be stopped at any time by opening the main door. To restart dryer,
shut the main door and press desired setting.
NOTE: When a cycle is interrupted by opening the main door, cycle time will continue to count
downward, regardless if the door is open or closed, until a keyboard (touch pad) selection is
made.