Wagner Project Sprayer - Manual (Page 10)

English 10
Title
Using the Quick Flush Lid (latex materials only)
Cleaning the material container:
1. Unplug the sprayer. Pour the
remaining material back into the
original container. Remove the
suction tube.
4. Slide the pump housing assembly
off the sprayer. Remove the
piston and spring from the pump
housing. Place all removed parts
(except the pump housing) into the
material container (see inset).
9. Depending on the thickness of
the material, some residue may
remain on the sprayer parts.
Remove any remaining residue
with the cleaning brush and the
appropriate cleaning solution.
7. Thread a garden hose into the Quick Flush lid, and
place entire container and cap into an empty bucket.
2. Turn the spray tip
counterclockwise until it is
removed. Pull out the atomizer
valve, being careful not to lose it.
5. Snap Quick Flush lid into place on
the pump housing ring as shown.
10. IMPORTanT: Make sure to
completely remove all material
from the inside of the piston
chamber by scrubbing with the
brush. even a small amount of
material can dry like glue and
keep the piston from moving,
causing damage to the sprayer.
3. Using the spray tip, turn the
locking nut counterclockwise until
it is removed.
6. Thread the Quick Flush lid onto
the material container.
11. IMPORTanT: Make sure to
keep the vent hole (a) on the
pump housing clean and
unblocked or a vacuum can
build up in the container and
cause damage to the sprayer. a
toothpick or straightened paper
clip can be used to clean it.
8. SLOWLy turn on the garden hose. Let the water run for
approximately 30 seconds. Turn the water off, remove
the garden hose and Quick Flush lid from the material
container, and properly dispose of the cleaning solution.
Be careful not to lose any of the parts that are still in
the material container!
you will need a garden hose to complete the steps below. If you do not have a garden hose available, or if you used oil-
based materials, follow the Cleanup for Oil-Based Materials instructions on page 12-13.
IMPORTanT: an empty
bucket is needed because
water will flow from the side
port (a) of the Quick Flush
lid when the hose is turned
on.
(a)
(a)
0
30
15 45